Rather than completely a protoype out of cardboard i have decided to experimetn as i go. keeping in mind i have other assignments to do, and i dont have a lot of time. I often find that its with the materials you use that yu run into problems. therefore i dont want to be wasting any time using cardboard.
Here is a checklist, a list of steps in which i plan to take in order to create the cube.
1.cut out the peices for the cube (6 sides from acrylic)
2. stick all sides together minus front and back in which will have the slots in it. (this is to experimetn with sticking methods)
3. create the slides in regards to the front and back sides of the cube.
4. find appropriate sized beads for the 3 holey slides.
5. Drill holes to fit the beads through thm in each slide.
6. stick down the back side
7. insert the beads
8. stick down the front side
9. insert th slides.
i realise that this sounds all very easy but along the way i realise that time consuming trial and error may occur and that ths may change slightly however the method is a good basis for me to start with.
No comments:
Post a Comment